magicolor 330 - Base Engine Service Manual 9-131
Removal and Replacement Procedures
RRP 9.63 Cyan (C) Developer Assembly (PL7.1.30)Removal
1. Open the Front Cover.
2. Remove the Cyan Toner Cartridge (RRP 9.57).
3. Remove the Xerographic Cartri dge (RRP 9.48).
4. Remove the Top Cover Assembly (RRP 9.3).
5. Remove the Inner Cover Assembly (RRP 9.2).
6. Remove the Used Cartridge Sensor (RRP 9.70).
7. Remove the screw securing the Rotary Lat ch to the front of the printer frame and remove the Latch.
8. Turn the Rotary Knob until the large, shoulder screw securing the Cyan Developer Assem bly to the
Rotary Frame appears through the access hole a few inches above the Rotary Knob.
9. Remove the shoulder screw s ecuring the Cyan Developer Assembly to the Rotary Frame.
10. Reaching in through the top of the printer, slide the Cyan Developer Assembly to the front of the printer
to free the gears at the rear of the Developer Assembly.
11. Make sure you do not damage the Exit Ac tuator as you lift the front of the Cyan Developer Assembly to
free the front of the Assembly from the front of the printer frame, and remove the Assembly.
Replacement
1. Turn the Rotary Knob until you can access the Cyan Develo per Assembly cavity through the top of the
printer.
There is a "C" molded into the rear of the Cyan Developer Assembly cavity.
2. Hold the Cyan Developer As sembly so the rear, or gear end, of the Assembly is slightly lower than the
front.
3. Slide the rear of the Assembly into the locating pins located at the rear of the Cyan Developer Assem-
bly.
4. Lower the front end of the Ass embly making sure you do not damage the Exit Actuator.
5. Reposition the Cyan Developer Assem bly until the Assembly seats firmly in the Rotary Frame and the
screw hole at the front of the Assembly lines up with the screw hole at the front of the Rotary Frame.
6. Turn the Rotary Knob until the screw hole in the front of the Cyan Developer Asse mbly appears
through the access hole a few inches above the Rotary Knob.
7. Use a large, shoulder screw to secu re the Cyan Developer Assembly to the Rotary Frame.
8. Reinstall the Used Cartridge Sen sor (RRP 9.70).
9. Reinstall the Rotary Latch to the front of the printer frame and use one screw to secure the Latc h to the
frame.
10. Reinstall the Inner Cover Asse mbly (RRP 9.2).
11. Reinstall the Top Cover Assembly (RRP 9.3).
12. Reinstall the Xerographic Cartri dge (RRP 9.48).
13. Reinstall the Cyan Toner Cartridge (RRP 9.57).
14. Close the Front Cover.