Minolta 330 2, 3, 4, 5, 6

3-60 magicolor 330 - Base Engine Service Manual

Primary FIPS: Error Messages

There is a problem with the Large Capacity Input Feeder Cover.

Logic control on the MCU PWB detected that the LCIF Feeder Cover Interlock is deactuated.

Step Actions and Questions Yes No

SUSPECT COMPONENTS

The following components are associated with this specific prob-

lem. One or more of these components may have failed partially

or completely. If you cannot isolate the problem using this FIP,

replace each component listed below, one at a time, until the prob-

lem disappears.

• Wiring and connectors linking the components

1FEEDER COVER MISSING

1. Open the Feeder Cove r.

2. Firmly close the F eeder Cover.

Does the error message still appear?

Go to step 2 Problem

solved

2LCIF FEEDER COVER SWITCH INSPECTION

1. Open the Feeder Cove r.

2. Inspect the Feed er Cover Switch actuator that is located

near the top-rear of the Cover.

Is the actuator free of damage?

Go to step 4 Go to step 3

3Replace the LCIF Cover Assembly (LCIF RRP 6.8)

Does the error message still appear?

Go to step 4 Problem

Solved

4Replace the Feeder Cover Switches (LCIF RRP 6.14)

Does the error message still appear?

Go to step 5 Problem

Solved

5Replace the Feeder PWB (LCIF RRP 6.10)

Does the error message still appear?

Go to step 6 Problem

Solved

6Replace the MCU PWB (RRP 9.123)

Does the error message still appear?

Go to suspect

components

Problem

Solved