magicolor 330 - Base Engine Service Manual 9-237
Removal and Replacement Procedures
RRP 9.116 Dispense Motor Assembly (PL11.1.22)
Removal
1. Remove the Rotary Motor PWB (RRP 9.115).
2. Remove the two screws securing the Dispe nse Motor to the printer frame.
3. Slide the Dispense Motor up and slight ly to the left to free the Motor shaft gear from the frame, and
remove the Motor (inset).
4. Disconnect P/J 55 from the Dis pense Motor.
Replacement
1. Reconnect P/J 55 to the Di spense Motor.
2. Position the Dispense M otor so the P/J connector is facing to the right.
3. Reinstall the Dispense Motor by inserting the Motor sh aft gear into the large key slot then sliding the
Motor down so the shaft rests in the large key slot (inset).
4. Line up the two screw holes in the Motor with the two screw holes in the printer frame.
5. Use two screws to secure the Motor to the fra me.
6. Reinstall the Rotary Motor PWB (RRP 9.115).