Minolta 330 1

3-6 magicolor 330 - Base Engine Service Manual

Primary FIPS: Error Messages

Black image density is too low.

Logic control on the MCU PWB detected that the ADC Sensor reads the black patch density as being below specifi-

cation and that the reading is either slow to raise or does not raise after the printer attempts to increase density.

Step Actions and Questions Yes No

SUSPECT COMPONENTS

The following components are associated with this specific prob-

lem. One or more of these components may have failed partially

or completely. If you cannot isolate the problem using this FIP,

replace each component listed below, one at a time, until the prob-

lem disappears.

• Black Developer (RRP 9.66)

• Black Developer Assembly (RRP 9.65)

• LVPS (RRP 9.119)

• HVPS (RRP 9.120)

• Developer Clutch Assembly (RRP 9.117)

1Replace the Black Toner Cartridge with a new one (RRP 9.58)

Does the error message still appear?

Go to step 2 Problem

solved

2Replace the Dispense Motor (RRP 9.116)

Does the error message still appear?

Go to step 3 Problem

solved

3Replace the ADC Sensor (RRP 9.50)

Does the error message still appear?

Go to step 4 Problem

solved

4Replace the OPC Drum (RRP 9.48)

Does the error message still appear?

Replace the

MCU PWB

(RRP 9.123)

Problem

solved