magicolor 330 - Base Engine Service Manual 9-7
Removal and Replacement Procedures
RRP 9.1 Front Cover Assembly (PL1.1.1)
Removal
1. Slide Tray 1 halfway out of the pri nter.
2. Open the Front Cover and let it rest on top of Tray 1.
3. Remove the two screws securing the two Hinge Plates to the Front Cover and remove the Plates.
4. Two the two screws securing the two Front Cover Supports to the printer frame.
5. Remove the Front Cover Ass embly from the printer.
Replacement
1. Slide Tray 1 halfway out of the pri nter.
2. Position the Front Cover Assem bly as shown in the figure, making sure the Cover lip is under the two
metal hinges that are protruding from the printer.
3. Let the Front Cover Asse mbly rest on top of Tray 1.
4. Reinstall each of the two Hing e Plates so one end of each Plate is over the metal hinges.
5. Align each Plate wit h the positioning tabs and screw holes on the Front Cover Assembly.
6. Use two screws to secure the two Hinge Plates to the Front Co ver Assembly, but tighten the screws
only halfway.
7. Reposition the Cover and the Plates , so the notches at the end of each Plate fit over each of the metal
hinges.
8. Tighten the two screws to secure the Hinge Plates to the Front Cover.
9. Reattach the two Front Cover Su pports to the frame and use two screws to secure the Supports.
10. Close and open the Front Cover A ssembly, making sure the Cover moves freely and without binding.
11. Slide Tray 1 back into the printer.