magicolor 330 - Base Engine Service Manual 9-185
Removal and Replacement Procedures
RRP 9.90 Exit-1 Roll Assembly (PL9.3.7)
Removal
1. Remove the Main Fuser Assembly (RRP 9.81).
2. Place the Fuser Tray Assembly on a fl at and stable work surface.
3. Remove the E ring securi ng the front of the Exit-1 Roll Shaft to the front bearing and slide the bearin g
back along the Shaft.
4. Slide the front of the Shaft along the slot in the front of the Fuser Tray Assembly so you can free the
rear of the Shaft from the rear bearing.
5. Remove the Shaft, along with the Exit-1 Gear, from the Fuser Tray Assembly.
Replacement
1. Make sure the rear be aring is still in place in the cutout at the rear of the Fuser Tray Assembly.
2. Slide the front bearing, with the collar facing the rubber rollers, over the front of the Exit-1 Roll Assem-
bly Shaft.
3. Slide the Exit-1 Gear, with the large side facing the rubber rollers, over th e rear of the Exit-1 Roll
Assembly.
4. Position the Shaft so the rubber rollers line up with the cutouts in the Fuser Tray Assembly.
5. Insert the front of the Shaft into the slot in the front of the Fuser Tray Assembly.
6. Insert the rear of the Shaft into th e rear bearing.
7. Slide the front of the Shaft tow ard the front bearing cutout in the Fuser Tray Assembly.
8. Slide the front bearing into p lace in the cutout and use an E ring to secure the Exit-1 Roll Shaft to the
front bearing.
9. Reinstall the Main Fuser Assembly (RRP 9.81).