magicolor 330 - Base Engine Service Manual 9-105
Removal and Replacement Procedures
RRP 9.50 ADC Sensor Assembly (PL6.1.20)
Removal
1. Remove the Xerographic Cartri dge (RRP 9.48).
2. Remove the Inner Cover Assembly (RRP 9.2).
3. Disconnect P/J 81 from the ADC Sensor Assembly.
4. Remove the E ring securing the front of the ADC Sensor Assembly to the front of the printer frame.
5. Reach inside the prin ter cavity and slide the front end of the ADC Sensor out of the hole at the fro nt of
the printer.
6. Pull the wire harness an d P/J 81 out through the grommet hole.
7. Lift the rear end of the ADC Sensor out o f the cutout at the rear of the printer and remove the ADC
Sensor.
The IBT is located next to the ADC Sensor Assembly. The IBT is easily scratched. When
removing the ADC Sensor be extremely careful that you do not touch the sur face of the
IBT with your fingers or with the ADC Sensor Assembly.
Replacement
1. Slide the shaft end of the A DC Sensor Assembly into the slot at the rear of the printer cavity.
2. Push the shaft far enough to the rear for you to slide the front of the shaft into the hole in the front of
the printer frame and the positioning tab into the slot next to the hole.
3. Slide the rear of the sh aft down into the rear slot.
4. Insert P/J 81 through the grom met hole.
5. Use an E ring to secure the fr ont of the ADC Sensor Assembly to the front of the printer frame.
6. Reconnect P/J 81.
7. Reinstall the Inner Cove r Assembly (RRP 9.2).
8. Reinstall the Xerographic C artridge (RRP 9.48).