magicolor 330 - Base Engine Service Manual 9-159
Removal and Replacement Procedures
RRP 9.77 Auger Assembly (PL8.1.40)
Removal
1. Remove the Transfer Assembly (RRP 9.71).
2. Remove 2nd BTR Assembly ( RRP 9.75).
3. Remove the Fuser Drive Assembly (RRP 9.110).
4. Remove the two screws securing the IBT Rear Brac ket to the rear of the printer frame and remove the
Bracket.
5. Remove the screw securi ng the Auger Drive Assembly to the printer frame (Figure 1).
6. Remove the screw securing the Auger Tube to the rear of the printer frame (Figure 2).
7. Remove the screw securing the Auger Assembly bracket to the rear of the printer frame (Figure 3).
8. Swing the bottom of the Auger Assembly out, then sl ide the Auger Assembly down and remove the
Assembly from the printer (Figure 4).
Replacement
1. Reinstall the Auger Asse mbly onto the printer (Figure 4).
2. Slide the Auger Assembly bracket into pos ition at the rear of the printer frame and use one screw to
secure the bracket.
3. Use one screw to secure the Aug er Tube to the rear of the printer frame.
4. Use one screw to secure the A uger Drive Assembly to the printer frame.
5. Reinstall the IBT Rear Bracket to the rear of the printer fram e and use two screws to secure the
Bracket.
6. Reinstall the Fuser Drive As sembly (RRP 9.110).
7. Reinstall the 2nd BTR Assem bly (RRP 9.75).
8. Reinstall the Transfer Assembly (RR P 9.71).