magicolor 330 - Base Engine Service Manual 9-109
Removal and Replacement Procedures
RRP 9.52 XL Rail Assembly (PL6.1.40)Removal
1. Remove the Xerographic Cartri dge (RRP 9.48).
2. Remove the ROS Assembly (RRP 9 .47).
3. Disconnect P/J 83 from the Waste Toner Sensor.
4. Disconnect P/J 89 from the Toner Box Sensor.
5. Free the wire harnesses fr om the wire clamps (Figure 1).
6. Disconnect P/J 86 from the Erase Lamp.
7. Remove the two screws securing the XL Rail Assembly to the front of the printer frame (Figure 2).
8. Remove the two screws securing the XL Rail Assembly to the rear of the printer frame
9. Lift the XL Rail Assembly up through the top of the printer frame.
Replacement
1. Move all of the wire harness es out of the way.
2. Lower the XL Rail Assembly drop th rough the top of the printer frame.
3. Insert the three tabs that are located at the rear of the XL Rail Assembly into the three holes at the rear
of the printer frame.
4. Position the front lip o f the XL Rail Assembly so it is on the outside front of the printer frame.
5. Line up the four screw hole s in the XL Rail Assembly with the four screw holes in the printer frame.
6. Use four screws to secure the Asse mbly to the printer frame.
7. Reconnect P/J 86 to the Er ase Lamp.
8. Reconnect P/J 89 to the Toner Box Sensor.
9. Reconnect P/J 83 to the Waste Toner Sensor.
10. Secure P/J 83 and P/J 86 u nder the wire clamps.
11. Reinstall the ROS Assembly (RRP 9.47).
12. Reinstall the Xerographic Cartri dge (RRP 9.48).