magicolor 330 - Base Engine Service Manual 9-209
Removal and Replacement Procedures
RRP 9.102 Upper Exit Assembly (PL10.1.2)
Removal
1. Open the Upper Exit Assembly.
2. Gently pry the Lower Exit Assembly rear pivot arm out of the pivot hole in the rear of the Upper Exit
Assembly and remove the Upper Exit Assembly.
Replacement
1. Position the Upper Exit A ssembly at about a 45° angle to the printer frame.
2. Insert the front pivot ho le of the Upper Exit Assembly into the front pivot arm of the Lower E xit Assem-
bly.
3. Push in the on the rear of the Upper Ex it Assembly enough so the rear pivot arm of the Lower Exit
Assembly fits into the rear pivot hole of the Upper Exit Assembly.
4. Open and close the Upper E xit Assembly to make sure it moves smoothly.