magicolor 330 - Base Engine Service Manual 9-25
Removal and Replacement Procedures
RRP 9.10 Front Snubber (PL2.2.9)
Removal
1. Remove Tray 1 from the printer.
2. Remove the two screws securing the Front Gui de to the Tray.
3. Remove the Guide, along with the attached Front Snubber, from the Tray.
4. Squeeze the end of the plastic fas tener securing the Front Snubber to the Guide and remove the fas-
tener.
5. Remove the Front Snubber from the Front Guide.
Replacement
1. Position the Front Sn ubber against the Front Guide, making sure the hole in the Snubber lines up wit h
the hole in the Guide.
2. Slide the through the hol e in the Front Snubber and press firmly until the fastener locks into place.
3. Slide the Snubber under the Bottom Plate Assembly, and hook the Snubber Latch through the cutout
in the side of the Tray.
4. Position the Front Guide so th e tabs in the Tray fit through the cutouts in the Guide.
5. Reposition the Front Guide so th e two screw holes in the Guide line up with the two screw holes in the
Tray.
6. Use two screws to secure the Front Guide to the Tray.
7. Reinstall Tray 1 into the printer.