magicolor 330 - Base Engine Service Manual 9-225
Removal and Replacement Procedures
RRP 9.110 Fuser Drive Assembly (PL11.1.2)
Removal
1. Slide out the Fuser Assembly (RRP 9.8 0).
2. Remove the Low Voltage Power Supply (RRP 9.119).
3. Remove the Paper Handling M otor Assembly (RRP 9.111).
4. Remove the wire harness from the Paper Handling Motor Bracket.
5. Remove the screw securing the Paper Handling Motor Bracket to the Fu ser Drive Assembly and
remove the Bracket.
6. Reach inside the empty Fuser Assembly cavity and remove the E ring securing the Fuser Drive Gear
shaft to the Auger Drive Assembly.
7. Remove the five screws securing the Fuser Drive Assembly to the printer frame and remov e the
Assembly.
Replacement
1. Reinstall the Fuser Drive A ssembly onto the printer frame by inserting the Drive Gears into the cutout
in the printer frame, and inserting the Fuser Drive Gear shaft into the hole in the Auge r Drive Assem-
bly.
2. Line up the five screw holes in the Fuser Drive Assembly with the five scr ew holes in the printer frame
and use five screws to secure the Fuser Drive Assembly to the frame.
3. Reach inside the empty Fuse r Assembly cavity and reinstall the E ring securing the Fuser Drive Gear
shaft to the Auger Drive Assembly.
4. Reinstall the Paper Handling Motor Bracket onto the Fuser Drive Assembly a nd use one screw to
secure the Bracket to the Assembly.
5. Reinstall the wire harnes s under the Paper Handling Motor Bracket.
6. Reinstall the Paper Hand ling Motor Assembly (RRP 9.111).
7. Reinstall the Low Voltage Power Supply (RRP 9.119).
8. Reinstall the Fuser Assembl y (RRP 9.80).