magicolor 330 - Base Engine Service Manual 9-85
Removal and Replacement Procedures
RRP 9.40 Pre-Registration Roll Assembly (PL5.2.4)
Removal
1. Remove the Pre-Registration Clutch (RRP 9.41).
2. Slide the green Pre-Regi stration Knob off of the Pre-Registration Shaft (Figure 1).
3. Remove two screws securing the MSI Out Holder t o the Main Paper Handling Assembly and pull the
Holder away from the Assembly.
4. Remove the E ring securin g the front of the Pre-Registration Shaft to the Main Paper Handling Assem-
bly frame.
5. Remove the E ring securing the Idler Gear to the rear of the Pre-Registr ation Shaft and remove the
Idler Gear (Figure 2).
6. Slide the Pre-Registrati on Roll Assembly to the rear of the Main Paper Handling Assembly, freeing the
front of the Shaft from front of the Main Paper Handling Assembly.
7. Slide the Pre-Registration Roll Assembly to the front, free the rear of the Shaft from the rear of the
Main Paper Handling Assembly.
8. Slide the Pre-Registr ation Roll Assembly free of Pre-Registration Gear 2 and remove the Shaft (Figure
3).
Replacement
1. Reinstall Pre-Registration Gear 2 into the no tch that is located at the rear of the Pre-Registration Roll
Assembly channel in the Main Paper Handling Assembly.
2. Slide the rear of the Pre-R egistration Roll Assembly through Gear 2 and into the rear hole of the Main
Paper Handling Assembly
3. Slide the Shaft far enough so you c an slide the front of the Shaft into the front hole of the Main Paper
Handling Assembly.
4. Seat the Pre-Registration R oll Assembly into the channel in the Main Paper Handling Assembly, mak-
ing sure the pin near the end of the shaft captures Gear 2.
5. If necessary, reinstall the bearings to the fr ont and rear of the Pre-Registration Shaft.
6. Reinstall the MSI Out Hold er to the Main Paper Handling Assembly and use two screws to secure the
Holder.
7. Reinstall the Idler Gear to the rear of the Pre-Registration Shaft and use an E ring to secure the Gear
to the Shaft.
8. Use an E ring to secure the front of the Pre-Registration Shaft to the front of the Main Pa per Handling
Assembly.
9. Reinstall the green Pre-Regi stration Knob onto the Pre-Registration Shaft.
10. Reinstall the Pre-Registration Clutc h (RRP 9.41).