magicolor 330 - Base Engine Service Manual 9-155
Removal and Replacement Procedures
RRP 9.75 2nd BTR Assembly (PL8.1.20)
Removal
1. Remove the Transfer Assembly (RRP 9.71).
2. Remove the Belt Cleaner A ssembly (RRP 9.76).
3. Reach through the empty Fuser Assembly ca vity and slide the 2nd BTR Assembly out of the IBT Front
and Rear Brackets and out of the printer.
Replacement
1. Position the 2nd BTR so the gears face the rear of the pr inter and place the 2nd BTR Assembly on the
frame inside the empty Fuser cavity.
2. Place your left hand on the rear of the 2 nd BTR and place your right hand on the front of the 2nd BTR
and push the 2nd BTR into the slots in the IBT Front and Rear Brackets.
3. Push hard on both end s to make sure the 2nd BTR has seated correctly.
4. Reinstall the Belt Cleaner Assembly (RRP 9.76).
5. Reinstall the Transfer Assembly (RR P 9.71).
6. Refer to Section 9 of this manual and reset the 2nd BTR Assembly Life Counter to zero.