magicolor 330 - Base Engine Service Manual 9-29
Removal and Replacement Procedures
RRP 9.12 Sector Gear (PL2.2.17)
Removal
1. Remove Tray 1 from the printer.
2. Position the Tray so the bottom faces up.
3. Remove the five screws securi ng the Bottom Cover to the Tray and remove the Bottom Cover (Figure
1).
4. Remove the Sector Gear Spring from the Sector Gear (Figure 2).
5. Slide the Sector Gear so it is free of the End Guide knob and remove the Sector Gear.
Replacement
1. Position Tray 1 so the bottom faces u p.
2. Place the round opening that is located on one arm of the Sector Gear over the End Guide knob.
3. Reposition the Sector Gear so the round tab on the bottom of the Tray fits through the hole located in
the center of the Sector Gear, making sure the End Guide knob remains attached to the arm of the
Sector Gear.
4. Press the Sector Gear ag ainst the bottom of the Tray, making sure the gear teeth mesh with the teeth
Tray Size Actuator and the positioning mark on the Gear lines up with the positioning mark on the Size
Actuator (Figure 3).
5. Squeeze the End Guide handles and slide the End Guide back and forth to make sure it moves
smoothly in the guide track and that the Sector Gear moves smoothl y against the Tray Size Actuator.
6. Reinstall the Sector Gear Spr ing onto the end of the Sector Gear.
7. Reinstall the Bottom Cover to th e Tray.
8. Use five screws to secure the Bottom Cover to the Tray.
9. Reinstall Tray 1 into the printer