magicolor 330 - Base Engine Service Manual 3-29
Primary FIPS: Error Messages

3.26 - Error Message: Adjust OPT3 Bin

There is a problem with the OPT3 tray or bin.
Logic control on the MCU PWB did not detect a paper tray installed in the OPT3 bin. Note: the Engine Diagnostic
Menu may refer to the the OPT3 Bin no paper sensor as Tray 4.
Step Actions and Questions Yes No
SUSPECT COMPONENTS
The following components are associated with this specific prob-
lem. One or more of these components may have failed partially
or completely. If you cannot isolate the problem using this FIP,
replace each component listed below, one at a time, until the prob-
lem disappears.
• Wiring and connectors linking the LCIF to the Base Engine
• Wiring and connectors linking the components
1PAPER TRAY INSPECTION
1. Remove the paper tr ay from OPT3 bin.
2. Inspect the Size Act uators at the rear of the Tray.
Are the Actuators intact and free of damage?
Go to step 2 Replace the
Paper Tray.
2Replace the OPT3 Bin Switch Assembly (LCIF RRP 6.13)
Does the error message still appear?
Go to step 3 Problem
solved
3Replace the Feeder PWB (LCIF RRP 6.10)
Does the error message still appear?
Go to step 4 Problem
solved
4Replace the MCU PWB (RRP 9.123)
Does the error message still appear?
Go to suspect
components
Problem
solved