magicolor 330 - Base Engine Service Manual 9-231
Removal and Replacement Procedures
RRP 9.113 Process Drive Assembly (PL11.1.10)
Removal
1. Remove the Xerographic Cartri dge (RRP 9.48).
2. Remove the Paper Handling Dr ive Assembly (RRP 9.109).
3. Disconnect P/J 51 and P/J 52 leading to the Process Motor PWB and unhook the wires from the wire
harness clip that is attached to the Process Drive Assembly.
4. Remove the screw securing the HVP S Bracket and move the Bracket out of the way.
5. Hold on to the Process Drive Assembly, it is heavy, while you remove the seven screws securing the
Assembly to the printer frame and carefully pull the Assembly away from the frame.
Replacement
1. Reinstall the Process Drive Assemb ly onto the printer frame, making sure you line up the positioning
slot at the top left side of the Assembly with the positioning pin on the printer frame.
2. Use seven screws to secure t he Process Drive Assembly to the printer frame.
3. Reinstall the HVPS Bracket to the printer frame and use one screw to secure the Bracket.
4. Reconnect P/J 51 and P/J 52 leading to the Process Motor PWB and hook the wires under the wire
harness clip that is attached to the Process Drive Assembly.
5. Reinstall the Paper Handli ng Drive Assembly (RRP 9.109).
6. Reinstall the Xerographic C artridge (RRP 9.48).