Maintenance 181
Table 46
ICB CLI command summary (Continued)
Menu and command | Items and commands |
|
|
Port maintenance: | Port Status Display: PS |
PM | Displays status of all ICB ports as follows: Idle, Dialing_out, Ringing, |
| Talking, or Disabled. |
| Port Disconnect: PD |
| Disconnect a specific port from the conference. |
|
|
Report Generation: | Meetings Log Browser: ML |
RG | Browse the meeting log (see “CLI Meetings Log Report” on page 199). |
| Log ordering: ORDer_mlog |
| Prompts for the same parameters (year, month, day) and displays the log |
| contents sorted by access DN. The advantage is that all records of each |
| specific conference appear together. |
|
|
ICB fault isolation and correction
Alarm clearing procedures for the ICB are the identical to those for other IPE cards.
FOR MORE INFORMATION
Refer to the following documents for additional information about how to clear alarms:
•Meridian 1 – Fault Clearing
•Meridian
Table 47 describes ICB service problems and the test procedures used to solve these problems.
Note: If the problem cannot be solved after using all available diagnostic tools and test procedures, list the symptoms observed and contact your Nortel Networks representative.
Table 47
ICB equipment problems
Symptoms | Diagnosis | Solution |
|
|
|
Red card LED on | Card is disabled or | Check the card status and perform a |
the ICB is | faulty. | card by pulling it out and plugging it back in, or from the |
permanently on. |
| CLI using the cr command under the SMaint menu. |
|
|
|
Nortel Integrated Conference Bridge Service Implementation Guide
