Nortel Networks 555-4001-135, 553-3001-358 CS 2100/Meridian SL-100 configuration, Assign CDR data

Installation and configuration 55

Note: Because of the number and variety of DNs programmed for the dual-card setup, Nortel Networks recommends creating a dialing plan chart similar to Table 9 on page 54. Refer to this chart when configuring the primary and secondary card attributes, including the dual-card settings, in the administration BUI.

Finally, configure each port on the primary and secondary cards as a digital set. See Table 7 on page 49.

Assign CDR data

If charge account is used for CDR billing, then configure the feature Charge Account for CDR billing. Remember to define Key 9 on all ICB key ports. See Table 10.

Table 10

LD 15 – Define the charge account for CDR data

Prompt	Response	Description
REQ	CHG	Change customer data.
TYPE	CDR_DATA	CDR data block.
CHLN	23	Set the charge account number length to 23.

CS 2100/Meridian SL-100 configuration

Single-card configuration

After installing the ICB card(s) and connecting the terminal for CLI access and the server for BUI access, perform CS 2100/Meridian SL-100 database configuration. Figure 11 on page 56 shows the tables to datafill for single-card setup.

Note: If single-number access is being used, the DN pairs are not required. Instead configure a single-number access DN.

Nortel Integrated Conference Bridge Service Implementation Guide