Nortel Networks 6.1 manual Using a line pool to make a call, Press Enter a line pool access code

76 / Making calls

code is used in the same way as the line pool access code, but you may need to dial fewer following numbers if the route is set up to automatically dial part of the call number.

Your installer or customer service representative programs the line pool access codes and destination codes and gives each telephone access to the relevant line pools.

Everyone in the office should have a list of the line pool access codes and destination codes for the line pools their telephones can use.

Using a line pool to make a call

1.	Press	.
2.	Enter a line pool access code.

If you have￿a freefl›internal line, you can make a call using a line pool without entering the feature code first.

1. Select an internal line (intercom).

2. Dial the line pool access code.

Tip - If no lines are available in the line pool, you can use Ring Again at the busy tone. You are notified when a line in the line pool becomes available. See ‘‘Using Ring Again’’ on page 80.

Programming a memory button with a line pool feature code

When you program a button with the line pool feature code, you must enter a line pool access code after the feature code. The programmed line pool button accesses a specific line pool, not the line pool feature. See ‘‘Programming feature buttons’’ on page 149 for more information.

If you program a button with an indicator to access a line pool, when all the lines in a line pool are busy, the indicator for the line pool button turns on. The indicator turns off when a line becomes available.

Compact ICS 6.1 System Coordinator Guide P0603544 02