
Chapter 2 – First Time Installation and Configuration
Parameter
Description
Remote IP | Set the target network address for packet transmission. | |
Address | ||
| ||
|
| |
Subnet Mask | Set the subnet mask for the target network. | |
|
|
4If your IP network type is SIP only, go to step 7.
5To register the system to the gatekeeper, click the Gatekeeper tab, and configure related parameters in accordance with the table below:
Figure 2-9 IP Network Services – Gatekeeper
Table 2-3 Gatekeeper Setting
Parameter
Description
| Set the IP network type for the RMX 1000 system to | |
| make a call. You need to set it based on the call type | |
| used for the participant's endpoint. It can be set to: | |
| H.323: Only H.323 calls are supported. | |
IP Network Type | SIP: Only SIP calls are supported. | |
| H.323 & SIP: H.323 and SIP calls are supported at | |
| the same time. | |
| Settings of the gatekeeper related parameters are | |
| available only when the H.323 network type is selected. | |
|
| |
Register to Gatekeeper | Set whether or not to register with the gatekeeper. You | |
must check this option to set the parameters that follow. | ||
| ||
|
| |
Primary (Alternate) | Indicates whether or not the device is registered with the | |
Gatekeeper | primary (or alternate) gatekeeper. | |
|
| |
Gatekeeper IP Address | Set the IP address for the primary (or alternate) | |
gatekeeper. | ||
| ||
|
| |
Gatekeeper Port | The port number for the primary (or alternate) | |
gatekeeper. | ||
| ||
|
| |
System Prefix/E164. | Set the E.164 number for the system. | |
|
|