
Polycom RMX 1000 User Guide
Parameter
Description
System H.323 Alias
Set the H.323 alias for the system.
6If your IP network type is H.323 only, go to step 8.
7To configure the SIP server, click the SIP Server tab, and configure related parameters in accordance with the table below:
Figure 2-10 IP Network Services –SIP Server
Table 2-4 Configuration Description of SIP Server Parameters
Parameter
Description
| Set the IP network type for the RMX 1000 system to make | |
| a call. You need to set it based on the call type used for the | |
| participant's endpoint. It can be set to: | |
| H.323: Only H.323 calls are supported. | |
IP Network Type | SIP: Only SIP calls are supported. | |
| H.323 & SIP: H.323 and SIP calls are supported at the | |
| same time. | |
| Settings of the SIP server related parameters are available | |
| only when the SIP network type is selected. | |
|
| |
| Set the transport layer protocol used for communicating | |
Transport Type | with the SIP server. It needs to be consistent with the | |
| protocol supported by the SIP server. | |
|
| |
| Specifies whether to register RMX 1000 to the specified | |
Register to Server | SIP server. You need to set the SIP server related | |
| parameters after this function is enabled. | |
|
| |
Primary | Displays the registration status of the SIP server. | |
When registration of the preferred server fails, the | ||
Server/Alternate | ||
alternate server will function as the current | ||
Server | ||
server. | ||
| ||
|
|