Polycom 3150-16966-002, RMX 1000 manual 11-6, Server Address

Chapter 11 – IP Service Settings

Figure 11-5IP Service – SIP Server

Table 11-4Configuration Description of SIP Server Parameters

Parameter

Description

	Set the IP network type for the RMX 1000 system to make
	a call. You need to set it based on the call type used for the
	participant's endpoint. It can be set to:
	ƒ H.323: Only H.323 calls are supported.
IP Network Type	ƒ SIP: Only SIP calls are supported.
	ƒ H.323 & SIP: H.323 and SIP calls are supported at the
	same time.
	Settings of the SIP server related parameters are available
	only when the SIP-supporting network type is selected.
	Set the transport layer protocol used for communicating
Transport Type	with the SIP server. It needs to be consistent with the
	protocol supported by the SIP server.
	Specifies whether to register RMX 1000 to the specified
Register to Server	SIP server. You need to set the SIP server related
	parameters after this function is enabled.
Primary	Displays the registration status of the SIP server.
	When registration of the preferred server fails, the
Server/Alternate
	alternate server will function as the current in-use SIP
Server
	server.
Server Address	Provides the IP address of SIP server for registration
	service.

11-6