Configuration
CIP over ATM (RFC 1577)
Item | Description |
|
|
ATM IP Address | Enter the IP address within the subnet. Set to all |
| zeros to disable CIP. |
|
|
ATM Subnet Mask | The mask is the same for all Broadmore 1750s |
| on the network. |
|
|
Server Address | The address of the server containing the LIS. |
| This may be a workstation on the ATM network |
| or ATM switch. Set to zero if you want to use |
| AAL5 PVCs for CIP instead of SVCs. |
|
|
Peak Cell Rate | This controls the bandwidth allocation to RFC |
| 1577 support. |
|
|
Enable RIP | Normally disabled. Only set to Yes for router |
| operation as the CIP subnet server. |
|
|
This configures the Broadmore 1750. Some Broadmore 1750s may need routing table additions to recognize and respond to the control station via the ATM subnetwork.
These Broadmore 1750s will be configured individually, based upon network topology. Each unit may or may not have an Ethernet connection.
In the case of no Ethernet connection, the unit routes Ethernet traffic to the ATM by default. The Ethernet gateway setting is a null field. Follow the sequence on the next page to verify that no gateway is defined. Do this for each applicable Broadmore 1750 without an Ethernet connection.
Select System Management ↵
Select Configuration ↵
Select System Services ↵
Select Configure IP ↵
Select Gateway 0.0.0.0 (correct if necessary)
Broadmore 1750 - Release 4.6 |
