Module and Fan Installation
Precautions
Precautions
The Broadmore 1750 chassis is normally shipped with modules and fan tray installed at the factory. If they have been shipped separately, observe the following precautions when unpacking, handling, and installing these assemblies.
WARNING! THE FRONT AND REAR COVERS OF THE CHASSIS SHOULD ONLY BE REMOVED FOR MODULE INSTALLATION AND MAINTENANCE AS REQUIRED. THE COVERS SHOULD BE REPLACED AS SOON AS POSSIBLE AFTER SUCH TASKS ARE COMPLETED.
WARNING! THE BROADMORE CONTAINS CIRCUIT CARDS AND
COMPONENTS THAT ARE SUBJECT TO DAMAGE BY ELECTROSTATIC DISCHARGE (ESD). DO NOT REMOVE A COMPONENT FROM ITS
PROTECTIVE PACKAGING UNTIL READY TO INSTALL IT. WEAR A WRIST GROUNDING STRAP AND ATTACH IT TO AN ESD CONNECTOR OR A METAL PART OF THE SYSTEM UNIT BEFORE HANDLING COMPONENTS. IF A WRIST STRAP IS NOT AVAILABLE, MAINTAIN CONTACT WITH THE SYSTEM UNIT THROUGHOUT ANY PROCEDURE REQUIRING ESD PROTECTION.
NOTE: After installation is complete, ensure that blank panels cover all empty module slots to provide proper cooling when the fan is turned on.
Broadmore 1750 - Release 4.6 |
