Broadmore 1750 - Release 4.6 7-35
Configuration
CPU Redundancy
Synchronizing CPU
CAUTION! MODULE REMOVAL AND INSERTION – ON A POWERED-UP
SYSTEM, WAIT AT LEAST 15 SECONDS AFTER ANY MODULE REMOVAL OR
INSERTION TO ALLOW THE SYSTEM TO STABILIZE. FAILURE TO FOLLOW THIS
PROCEDURE MAY RESULT IN SYSTEM ERRORS REQUIRING TOTAL SYSTEM
REBOOT. WHEN INSTALLING A REPLACEMENT CPU IN A REDUNDANT CPU
SYSTEM, DO NOT REBOOT OR POWER DOWN THE SYSTEM BEFORE CPU
SYNCHRONIZATION IS COMPLETE AS INDICATED BY A SOLID STATUS LIGHT.
CPU data sync occurs automatically and should not require user intervention (see
“CPU Sync” on page 8-17). If there is a CPU sync problem, follow the steps below
to synchronize da ta and operating software (SW) between the two CPUs. This
should only be done when there is file manipulation unknown to the system, such
as FTP of new files to the online CPU.
Three options are available for synchronizing CPU: Sync CPU Data Only,
Sync Operating SW, and Sync CPU Data and SW. Synchronizing the
operating software is very time-consuming and should only be done as a last resort
when the standby CPU has no Ethernet connection to update the software by FTP.
Select Maintenance/Diags ↵
Select Redundancy ↵
Select CPU ↵
Select Sync CPU Data Only ↵