SNMP Configuration
Notify Filters
NOTE: Selecting Validate Table will check that each Profile Name in this table exists in the Notify Profiles table.
The Notify Filters table is used to avoid sending traps for specific mib variables. Each variable in the VarBindList is checked against the Subtree. If a match occurs, the trap is not sent.
The following table describes the selections.
Item | Options | Comments |
|
|
|
Profile Name | string | Value for Profile Name, 1 to 30 characters. |
|
| Note: This entry must agree with the Profle Name |
|
| in the Notify Profiles table (see “Notify Profiles” |
|
| on page |
|
|
|
Subtree | bit string | The MIB tree address indicating the branch nodes |
|
| to be filtered. |
|
|
|
Subtree Mask | bit string | The "mask" is a bit string where a “1” ignores the |
|
| corresponding OID bit and a “0” indicates a wild |
|
| card match for the corresponding OID bit. A string |
|
| of all “1” bits will accept any OID. |
|
|
|
Type | Included | Must be same as in Notify table. |
| Excluded |
|
|
|
|
Enabled | Enabled | Enables/disables this filter. |
| Disabled |
|
|
|
|
Storage | Volatile | Settings lost without power. |
| Settings can be changed. | |
| Permanent | Settings can not be deleted. |
| Readonly | Settings can not be changed. |
| Other |
|
|
|
|
Broadmore 1750 - Release 4.6 |
|
