Module and Fan Installation
Installation Sequence
Installation Sequence
The Broadmore 1750 is shipped in a minimum usable configuration. Unused slots are covered with blank panels except the slots for a single NIM, SAM, or CPU.
NOTE: After installation is complete, ensure that blank panels cover all empty module slots to provide proper cooling when the fan is turned on.
NIM, SAM, APM, and CPU cards are inserted from the front. IOM cards are inserted from the rear. All cards align in card guides for ease of installation and removal. Each card will have two retaining screws to hold it in place, one at the top and one at the bottom. These screws must not be used for seating or unseating the cards. Each card also has a set of ejectors, one on top and one at the bottom. These ejectors are used to unseat the card from the midplane connector for card removal.
NOTE: Modules with jumpers are normally configured before installing the modules in the chassis. However, modules are
Install modules in the following order:
NIM (1 or 2)
SAM (1 or more)
CPU (1 or 2)
NIM IOM (1 for each NIM)
SAM IOM (1 for each SAM)
Protection SAM IOM (1 in slot P)
CPU IOM (1 for each CPU)
NOTE: The APM and APM IOM are factory installed at the factory.
Broadmore 1750 - Release 4.6 |
