Carrier Access 1750 user manual Unstructured DS3 SAM Alarm Configuration

Configuration

Unstructured DS3 SAM

Item	Options	Comments
Network AIS	Activate/Deactivate	Sends Alarm Indication Signal to the network
		when activated.
Service AIS	Activate/Deactivate	Sends Alarm Indication Signal to the
		connected local service equipment when
		activated.
Loopback	Normal	Normal is no loopback.
	Local	Local sets a service side loopback (DS3) on the
	Remote	port.
		Remote sets a network side loopback (ATM)
		on the port.
		See diagram “Loopback Options” on page 5-20

Table 7-4: Unstructured DS3 SAM Alarm Configuration

Network Alarms	Options	Service Alarms
Cell Starvation	Ignore/Major/Minor	LOS
LOF	Ignore/Major/Minor	LOF
AIS	Ignore/Major/Minor	AIS
Idle	Ignore/Major/Minor	Idle
RAI	Ignore/Major/Minor	RAI
FEAC	Ignore/Major/Minor	FEAC
Sequence Errors	Ignore/Major/Minor	Line Code Violation
Excessive SNP Errors	Ignore/Major/Minor	Excessive SNP Errors
Excessive F-bit Errors	Ignore/Major/Minor	Excessive F-bit Errors
Excessive Parity Errors	Ignore/Major/Minor	Excessive Parity Errors
Excessive C-bit Errors	Ignore/Major/Minor	Excessive C-bit Errors
Excessive FEBE Errors	Ignore/Major/Minor	Excessive FEBE Errors

Follow the sequence below to set network alarms. DS3 alarms are set on a port basis with alarm definitions as shown.

7-46 Broadmore 1750 - Release 4.6