2-1004
Catalyst 6500 Series Switch Command Reference—Release7.6
78-15328-01
Chapter2 Catalyst 6500 Series Switch and ROM Monitor Commands
show snmp targetaddr
show snmp targetaddr
To display the SNMP target address entries in the snmpTargetAddressTable, use the show snmp
targetaddr command.
show snmp targetaddr [volatile | nonvolatile | read-only]
show snmp targetaddr [-hex] {addrname}
Syntax Description
Defaults The default storage type is nonvolatile.
Command Types Switch command.
Command Modes Normal.
Usage Guidelines If you use special characters for the addrname value (nonprintable delimiters for this parameter), you
must use a hexadecimal keyword, which is one or two hexadecimal digits separated by a colon (:); for
example, 00:ab:34.
The read-only keyword is supported f or secur i ty m odel v 3 o nly.
Examples This example shows how to display specific target address information in the snmpTargetAddressTable:
Console> (enable) show snmp targetaddr cisco
Target Address Name: cisco
IP Address: 170.0.25.1
UDP Port#: 165
Timeout: 100
Retry count: 5
Tag List: tag1 tag2 tag3
Parameters: jeorge
Storage Type: nonvolatile
Row Status: active
Console> (enable)
volatile (Optional) Specifies the storage type is defined as temporary memory a nd
the content is deleted if the device is turned off.
nonvolatile (Optional) Specifies the storage type is defined as persistent memory and
the content remains after the device is turned off and on again.
read-only (Optional) Specifies that the storage type is defined as read only.
-hex (Optional) Displays addrname as a hexadecimal character.
addrname Name of the target agent; the maximum length is 32 bytes.