2-706
Catalyst 6500 Series Switch Command Reference—Release7.6
78-15328-01
Chapter2 Catalyst 6500 Series Switch and ROM Monitor Commands
show cops
show cops To display COPS information, use the show cops command.
show cops info [diff-serv | rsvp] [noalias]
show cops roles
Syntax Description
Defaults This command has no default settings.
Command Types Switch command.
Command Modes Normal.
Usage Guidelines A few minutes after a switchover occurs between active and redundant supervisor engines, if you enter
the show cops roles command, the output may be incorrect. If this is the case, the following warning is
displayed:
COPS High Availability Switch Over in progress, hardware may be
programmed differently than as suggested by the output of these
commands.
Examples This example shows how to display COPS status and configuration inform ation :
Console> show cops info
COPS general configuration
---------------------------
COPS domain name : -
Connection retry intervals : initial = 30 seconds
increment = 30 seconds
max = 300 seconds
COPS Diff-Serv client state
---------------------------
COPS connection state :not-connected
Last active server :172.20.25.3 [port:3288]
Primary configured server :172.20.25.3 [port:3288]
Secondary configured server :-
COPS RSVP client state
------------------------
info Displays COPS status and configuration information.
diff-serv (Optional) Specifies the differentiated services server table.
rsvp (Optional) Specifies the RSVP server table.
noalias (Optional) Forces the display to show only IP addresses, not IP aliases.
roles Displays the ports assigned to each role.