2-408
Catalyst 6500 Series Switch Command Reference—Release7.6
78-15328-01
Chapter2 Catalyst 6500 Series Switch and ROM Monitor Commands
set port macro
set port macro
To execute a configuration macro on a per-port basis, use the set port macro command.
set port macro mod/ports... ciscoipphone vlan vlan [auxvlan auxvlan]
set port macro mod/ports... ciscosoftphone vlan vlan
Syntax Description
Defaults This command has no default settings.
Command Types Switch command.
Command Modes Privileged.
Usage Guidelines When you use automatic voice configuration with the ciscoipphone keyword, some of the QoS
configuration requires phone-specific configuration (trust-ext, ext-cos), which is supporte d only on th e
following phones: Cisco IP Phone 7910, Cisco IP Phone 7940, Cisco IP Phone 7960, and Cisc o IP
Phone 7935. However, the ciscoipphone keyword is not exclusive to these models only; any phone can
benefit from all the other QoS settings that are configured on the switch.
To configure the QoS settings and the trusted boundary feature on the Cisco IP Phone, you must enable
Cisco Discovery Protocol (CDP) version 2 or later on the port. You need to enable CDP only for the
ciscoipphone QoS configuration; CDP does not affect the other components of the automatic voice
configuration feature.
The automatic voice configuration commands do not support channeling.
A PFC or PFC2 is not required for the ciscoipphone keyword.
A PFC or PFC2 is required for the ciscosoftphone keyword.
The ciscoipphone keyword is only supported on 10/100 and 10/100/1000 Ethernet ports.
The ciscosoftphone keyword is supported on all Ethernet ports.
mod/ports... Number of the module and the ports on the module.
ciscoipphone Specifies the Cisco IP Phone configuration macro.
vlan Specifies a VLAN interface.
vlan Number of the VLAN.
auxvlan (Optional) Specifies an auxiliary VLAN
auxvlan (Optional) Number of the auxiliary VLAN.
ciscosoftphone Specifies the Cisco Softphone configuration macro.