Cisco Systems 78-15328-01 show mls entry cef

2-800
Catalyst 6500 Series Switch Command Reference—Release7.6
78-15328-01
Chapter2 Catalyst 6500 Series Switch and ROM Monitor Commands
show mls entry cef
show mls entry cef
To display CEF and adjacency entries (and Tx statistics) for IP resolved entries and IPX resolved or
connected entries, use the show mls entry cef command.
show mls entry cef [adjacency]
show mls entry cef [short | long]
show mls entry cef ip [[ip_addr/]mask_len] [adjacency]
show mls entry cef ipx [[ipx_addr/]mask_len] [adjacency]
Syntax Description
Defaults This command has no default settings.
Command Types Switch command.
Command Modes Normal.
Usage Guidelines This command is supported on Catalyst 6500 series switches configured with the Supervisor Engine 2
with Layer 3 Switching Engine II (PFC2) only.
In the NextHop-IP field, the output may actually be set to “point2point” if the next hop is a point-to-point
WAN interface.
When you enter the show mls entry cef adjacency command, only adjacency information for those IP
or IPX CEF entries that are of type resolved, wildcard, or default are displayed.
adjacency (Optional) Displays adjacency information.
short (Optional) Displays the output with carriage returns.
long (Optional) Displays the output on one line.
ip Specifies IP entries.
ipx Specifies IPX entries.
ip_addr (Optional) IP address of the entry.
mask_len (Optional) Mask length associated with the IP or IPX address of the entry;
valid values are from 0 to 32.
ipx_addr (Optional) IPX address of the entry.