2-405
Catalyst 6500 Series Switch Command Reference—Release7.6
78-15328-01
Chapter2 Catalyst 6500 Series Switch and ROM Monitor Commands set port l2protocol-tunnel
•20 Layer 2 protocol tunneling port x 50 VLANs
•100 Layer 2 protocol tunneling port x 10 VLANs
Note The shutdown threshold factor should exceed the drop threshold factor. After reaching th e drop threshold
factor, the port or range of ports starts dropping PDUs. After reaching the shut down threshold factor, the
port or range of ports goes into errdisable state and is restored after timeout.
Examples This example shows how to enable CDP on a range of ports:
Console> (enable) set port l2protocol-tunnel 7/1-2 cdp enable
Layer 2 protocol tunneling enabled for CDP on ports 7/1-2.
Console> (enable)
This example shows how to enable STP and VTP on a range of ports:
Console> (enable) set port l2protocol-tunnel 7/1-2 stp vtp enable
Layer 2 protocol tunneling enabled for STP VTP on ports 7/1-2.
Console> (enable)
This example shows how to disable CDP, STP, and VTP on a range of ports:
Console> (enable) set port l2protocol-tunnel 7/1-2 cdp stp vtp disable
Layer 2 protocol tunneling disabled for CDP STP VTP on ports 7/1-2.
Console> (enable)
This example shows how to set the drop threshold to 1000 and the shutdown threshold to 20000 on a port:
Console> (enable) set port l2protocol-tunnel 7/1 drop-threshold 1000 shutdown-threshold
20000
Drop Threshold=1000, Shutdown Threshold=20000 set on port 7/1.
Console> (enable)
Related Commands clear l2protocol-tunnel cos
clear l2protocol-tunnel statistics
set l2protocol-tunnel cos
show l2protocol-tunnel statistics
show port l2protocol-tunnel