2-685
Catalyst 6500 Series Switch Command Reference—Release7.6
78-15328-01
Chapter2 Catalyst 6500 Series Switch and ROM Monitor Commands show channel
show channel
To display EtherChannel information for a channel, use the show channel co mmand.
show channel [channel_id] [info | statistics | mac]
show channel [channel_id] [info [type]]
show channel [channel_id | all] protocol
Syntax Description
Defaults This command has no default settings.
Command Types Switch command.
Command Modes Normal.
Usage Guidelines If you do not specify the channel_id value, EtherChannel information is shown for all channels.
No information is displayed if the channel specified is not in use.
If you enter the optional info type, the specified feature-related parameters are displayed in the output.
To display protocols on all channels, enter the show channel all protocol command.
Examples This example shows how to display channel information for a specific channel:
Console> show channel 865
Channel Ports Status Channel
id Mode
------- ----------------------------------------------- --------- --------------
865 4/1-2 connected desirable
non-silent
Console>
channel_id (Optional) Number of the channel.
info (Optional) Displays channel information.
statistics (Optional) Displays statistics about the port (PAgP packets sent and
received).
mac (Optional) Displays MAC information about the channel.
type (Optional) Displays feature-related parameters; valid values are
spantree, trunk, protcol, gmrp, gvrp, qos, rsvp, cops, dot1qtunnel,
auxiliaryvlan, and jumbo.
all (Optional) Displays protocols of all channels.
protocol Displays channel protocol.