2-649
Catalyst 6500 Series Switch Command Reference—Release7.6
78-15328-01
Chapter2 Catalyst 6500 Series Switch and ROM Monitor Commands set vlan
Defaults The default values are as follows:
•Switched Ethernet ports and Ethernet repeater ports are in VLAN 1.
•said is 100001 for VLAN 1, 100002 for VLAN 2, 100003 for VLAN 3, and so forth.
•type is Ethernet.
•mtu is 1500 bytes.
•state is active.
•hopcount is 7.
•pvlan type is none.
•mistp_instance is no new instances have any VLANs mapped. For an existing VLAN, the existing
instance configuration is used.
Command Types Switch command.
Command Modes Privileged.
Usage Guidelines This command is not supported by the NAM.
If you are configuring normal-range VLANs, you cannot use the set vlan command until the
Catalyst 6500 series switch is either in VTP transparent mode (set vtp mode transparent) or until a
VTP domain name has been set (set vtp domain name). To create a private VLAN, UTP mode must be
transparent.
If you set the VTP version to 3, VLAN 1 (the Cisco default VLAN) and VLANs 1002-1005 are
configurable. If your switch has VTP version 1 or VTP version 2 neighbors, only default values are
advertised for these VLANs. We recommend that you do not modify these VLANs if you want
interoperability with older versions of VTP.
stemaxhop hopcount (Optional) Specifies the maximum number of hops for Spanning Tree
Explorer frames; valid values are from 1to 14.
rspan (Optional) Creates a VLAN for remote SPAN.
firewall-vlan Specifies VLANs that are secured by a Firewall Services Module; see the
“Usage Guidelines” section for more information about specifying a VLAN
range for a Firewall Services Module.
mod Number of the Firewall Services Module.
msfc-fwsm-interface Specifies the VLAN that is to be the interface between the MSFC and the
Firewall Services Module.