2-406
Catalyst 6500 Series Switch Command Reference—Release7.6
78-15328-01
Chapter2 Catalyst 6500 Series Switch and ROM Monitor Commands
set port lacp-channel
set port lacp-channel
To set the priority value for physical ports, to assign an administ ra tive key to a particular set of ports, or
to change the channel mode for a set of ports that were previously assigned to the same administrative
key, use the set port lacp-channel command.
set port lacp-channel mod/ports port-priority value
set port lacp-channel mod/ports [admin-key]
set port lacp-channel mod/ports mode {on | off | active | passive}
Syntax Description
Defaults LACP is supported on all Ethernet interfaces.
The default port priority value is 128.
The default mode is passive for all ports that are assigned to the administrative key.
For differences between PAgP and LACP, refer to the “Guidelines for Port Configuration” section of the
“Configuring EtherChannel” chapter of the Catalyst 6500 Series Switch Software Configuration Guide.
Command Types Switch command.
Command Modes Privileged.
Usage Guidelines This command can only be used for ports belonging to LACP modules. This command cannot be used
on ports running in PAgP mode.
Higher priority values correspond to lower priority levels.
The following usage guidelines apply when you assign an administrat ive key to ports:
•If you do not enter a value for the administrative key, the switch chooses a value automatically.
•If you choose a value for the administrative key, but this value is already used in your switch, all the
ports associated with this value are moved to a new administrative ke y that is assigned automatically.
The previously used value is now associated with new ports.
mod/ports Number of the module and the ports on the module.
port-priority Specifies the priority for physical ports.
value Number of the port priority; valid values are from 1 to 255. See the
“Usage Guidelines” section for more information about the priority
value.
admin-key (Optional) Number of the administrative key; valid values are from 1
to 1024. See the “Usage Guidelines” section for more information
about the administrative key.
mode Specifies the channel mode for a set or ports.
on | off | active | passive Specifies the status of the channel mode.