2-327
Catalyst 6500 Series Switch Command Reference—Release7.6
78-15328-01
Chapter2 Catalyst 6500 Series Switch and ROM Monitor Commands set logging level
set logging level
To set the facility and severity level used when logging system messages, use the set logging level
command.
set logging level facility severity [default]
Syntax Description facility Value to specify the type of system messages to capture; facility types are
listed in Table 2 -12.
severity Value to specify the severity level of system messages to capture; severity
level definitions are listed in Ta ble 2-1 3.
default (Optional) Causes the specified logging level to apply to all sessions.
Table2-12 Facility Types
Facility Name Definition
all All facilities
acl access control list
cdp Cisco Discovery Protocol
cops Common Open Policy Service Protocol
dtp Dynamic Trunking Protocol
dvlan Dynamic VLAN
earl Enhanced Address Recognition Logic
filesys file system facility
gvrp GARP VLAN Registration Protocol
ip Internet Protocol
kernel Kernel
ld ASLB facility
mcast Multicast
mgmt Management
mls Multilayer Switching
pagp Port Aggregation Protocol
protfilt Protocol Filter
pruning VTP pruning
privatevlan Private VLAN facility
qos Quality of Service
radius Remote Access Dial-In User Service
rsvp ReSerVation Protocol
security Security
snmp Simple Network Management Protocol