2-808
Catalyst 6500 Series Switch Command Reference—Release7.6
78-15328-01
Chapter2 Catalyst 6500 Series Switch and ROM Monitor Commands
show mls multicast
If you disable DNS, no name can be specified or shown.
A warning message is displayed if you disable the Layer 2 multicast protocol when the multicast
multilayer switching (MMLS) feature is running.
If you place the MSFC on a supervisor engine installed in slot 1, the n th e MSFC is r ecog ni zed as
module 15. If you install the supervisor engine in slot 2, the M SFC is re cogni zed as modu l e 16.
Examples This example shows how to display global information about the IP MMLS entries on a switch
configured with the Supervisor Engine 1 with Layer 3 Switching Engin e (WS- F6K-PFC) :
Console> (enable) show mls multicast
Admin Status: Enabled
Operational Status: Inactive
Configured flow mask is {Source-Destination-Vlan} flow
Active Entries = 0
MSFC (Module 15): 0.0.0.0
Console> (enable)
This example shows how to display global information about the IP MMLS entries on a switch
configured with the Supervisor Engine 2 with Layer 3 Switching E ngin e II (PFC 2):
Console> (enable) show mls multicast
Admin Status : Enabled
Operational Status : Active
Total Entries : 104
MSFC (Module 15) :
IP Address : 1.1.1.1
Complete Flows : 30
Partial Flows : 10
MSFC (Module 16) :
IP Address : 2.2.2.2
Complete Flows : 50
Partial Flows : 14
Console> (enable)
Table 2 -45 describes the fields in the show mls multicast command output.
Table2-45 show mls multicast Command Output Fields
Field Description
Admin Status Status of whether MMLS feature has been administratively enabled or
not.
Operational Status Actual operational status of the MMLS feature.
Total Entries Number of shortcut entries that are currently installed.
MSFC Information about the internal RP connected to the supervisor engine.
IP Address IP address of the RP.
Complete Flows Total number of complete flows installed by this RP.
Partial Flows Total number of partial flows installed by this RP.