2-541
Catalyst 6500 Series Switch Command Reference—Release7.6
78-15328-01
Chapter2 Catalyst 6500 Series Switch and ROM Monitor Commands set snmp targetaddr
set snmp targetaddr
To configure the SNMP target address entries in the snmpTargetAddressTable, use the set snmp
targetaddr command.
set snmp targetaddr [-hex] {addrname} param [-hex] {paramsname} {ipaddr}
[udpport {port}] [timeout {value}] [retries {value}] [volatile | nonvolatile]
[taglist {[-hex] tag}] [[-hex] tag tagvalue]
Syntax Description
Defaults The defaults are as follows:
•storage type is nonvolatile.
•udpport is 162.
•timeout is 1500.
•retries is 3.
•taglist is NULL.
Command Types Switch command.
Command Modes Privileged.
-hex (Optional) Displays addrname, paramsname, tagvalue, and tag in a
hexadecimal format.
addrname Unique identifier to index the snmpTargetAddrTable; the maximum
length is 32 bytes.
param Specifies an entry in the snmpTargetParamsTable that provides
parameters to be used when generating a message to the target; the
maximum length is 32 bytes.
paramsname Entry in the snmpTargetParamsTa ble; the maximum length is 32bytes.
ipaddr IP address of the target.
udpport port (Optional) Specifies which UDP port of the target host to use.
timeout value (Optional) Specifies the number of timeouts.
retries value (Optional) Specifies the number of retries.
volatile (Optional) Specifies that the storage type is defined as temporary
memory and the content is deleted if the device is turned off.
nonvolatile (Optional) Specifies that the storage type is defined as persistent
memory and the content remains after the device is turned off and on
again.
taglist tag (Optional) Specifies a tag name in the taglist.
tag tagvalue (Optional) Specifies the tag name.