2-402
Catalyst 6500 Series Switch Command Reference—Release7.6
78-15328-01
Chapter2 Catalyst 6500 Series Switch and ROM Monitor Commands
set port inlinepower
set port inlinepower
To set the inline power mode of a port or group of ports, use the set port inlinepower command.
set port inlinepower mod/port {off | auto}
Syntax Description
Defaults The default is auto.
Command Types Switch command.
Command Modes Privileged.
Usage Guidelines This command is not supported by the NAM.
If you enter this command on a port that does not support the IP phone power feature, an e rr or message
is displayed.
You can enter a single port or a range of ports, but you cannot enter the module n umb er on ly.
An inline power-capable device can still be detected even if the inline power mode is set to off.
Caution Damage can occur to equipment connected to the port if you are not using a phone that can be configured
for the IP phone phantom power feature.
Examples This example shows how to set the inline power to off:
Console> (enable) set port inlinepower 2/5 off
Inline power for port 2/5 set to off.
Console> (enable)
This example shows the output if the inline power feature is not suppo rte d:
Console> (enable) set port inlinepower 2/3-9 auto
Feature not supported on module 2.
Console> (enable)
Related Commands set inlinepower defaultallocation
show environment
show port inlinepower
mod/port Number of the module and the port on the mod ule.
off Prevents the port from powering up even if an unpowered phone is connected.
auto Powers up the port only if the switching module has discovered the phone.