2-317
Catalyst 6500 Series Switch Command Reference—Release7.6
78-15328-01
Chapter2 Catalyst 6500 Series Switch and ROM Monitor Commands set lcperroraction
set lcperroraction
To configure how your system handles Link Control Protocol (LCP) errors when a module report s a n
ASIC problem to the NMP, use the set lcperroraction command.
set lcperroraction action
Syntax Description
Defaults The default is that the action level is set to ignore.
Command Types Switch command.
Command Modes Privileged.
Usage Guidelines Valid values for action levels are as follows:
•operator—The system displays a recommended action for you to take. The system also logs the
LCP error.
•system—The system automatically takes an action to handle the LCP error. The system also logs
the LCP error.
•ignore—No action is taken. The system only logs the LCP error.
Note Be careful when using the system value because the switch automatically takes action, including
possibly resetting or power cycling modules.
Examples This example shows how to set the action that handles an LCP error:
Console> (enable) set lcperroraction ignore
Console> (enable)
Related Commands show lcperroraction
action Action for handling LCP errors. See the “Usage Guidelines” section for more
information about valid values for action levels.