Hitachi SJ700-2 Frequency source setting, Run command source setting, No contact

Related code

A002: Run command source setting

C001 to C008: Terminal [1] to [8] functions

C019: Terminal [FW] active state

F004: Keypad Run key routing

Chapter 4 Explanation of Functions

4.2.4 Frequency source setting

The frequency source setting function allows you to select the method to input the frequency-setting command.

Motor rotation direction is inverted when -10 to 0V is given as frequency command to 02-L terminals.

Related code

A001: Frequency source setting

Item	Function code	Data	Description
		(00)	(Valid only when the OPE-SR is used)
			Use the control provided on the digital operator to set the frequency.
		01	Input the frequency-setting command via a control circuit terminal (0-L,
			OI-L, or O2-L).
		02	Use the digital operator (function "F001") or remote operator to set the
			frequency.
		03	Input the frequency-setting command via an RS485 communication
Frequency			terminal.
			Input the frequency-setting command from the board connected to
source	A001	04
			optional port 1.
setting
		05	Input the frequency-setting command from the board connected to
			optional port 2.
		06	Use the SJ-FB to input the frequency-setting command as a pulse train
			(see 4.2.21)
		07	Use the SET-Freq command of the easy sequence function as the
			frequency-setting command.
		10	Use the operation result of the set frequency operation function as the
			frequency-setting command. (see 4.2.12)

4.2.5 Run command source setting

The run command source setting function allows you to select the method to input operation commands (to start and stop the motor). As the operation commands via control circuit terminals, turn the FW signal (for forward operation) or RV signal (for reverse operation) on and off to start and stop the motor, respectively.

(Note that the factory setting assigns the FW signal to intelligent input terminal [8].)

To switch each intelligent input terminal between a and b contacts, specify each terminal with function "C011" to "C019", and then perform input a/b (NO/NC) selection for each terminal.

When using the digital operation for the inverter operation, specify the desired motor operation direction with function "F004", and use the RUN and STOP/RESET keys to start and stop the motor, respectively. If the start commands for both forward and reverse operations are input at the same time, the inverter will assume the input of a stop command.

Item	Function code	Data	Description
		01	Input the start and stop commands via control circuit
			terminals (FW and RV).
		02	Input the start and stop commands from the digital or
Run command	A002		remote operator.
source setting		03	Input the start and stop commands via RS485
			communication terminals.
		04	Input the start and stop commands from option board 1.
		05	Input the start and stop commands from option board 2.
Terminal [FW]	C019	00	a (NO) contact
active state	C011 to C018	01	b (NC) contact

Note 1: If function "31" (forcible operation) or "51" (forcible-operation terminal) is assigned to an intelligent input terminal, the settings made with functions "A001" and "A002" will be invalidated when the said intelligent input terminal is turned on and those methods to input frequency-setting and operation commands which are specified for the said terminal will be enabled.

Note 2: On the remote operator (SRW) being used to operate the inverter, pressing the REMT (remote) key enables you to input both frequency-setting and operation commands from the remote operator.

4 - 8