LED indicators 1043
Faceplate buttons
Reset Reset (RST) generates a hard reset of the card.
Init Init (INI) generates a manual initialization of the software.
DIP switch The DIP switch selects the media drive. CF MASTER/POSITION1 selects
the Compact Flash (CF) FMD and HD MASTER/POSITION2 selects the
Hard Drive FMD.
LED indicators

Status LED

The functionality of the Status LED is summarized in the followingtable.
Table428
Status LED functionality
LED Color CP PM Status
Status Green After sysload
Flashing Green Not implemented
Yellow Not implemented
Orange Selftest error
Red During sysload phase 2
Flashing Red During sysload phase 1
Off No power

Active CPU LED

The CP PM can operate in single CPU mode or dual CPU mode. A tri-color
LED indicates the Call Server redundancy status. This LED is not used by
the Signaling Server and is OFF if it is a Signaling Server. The functionality
of the active CPU LED is summarized in the following table.
Table429
Call server redundancy status
LED Color Status
Call server redundancy Green Redundant mode, active
Yellow Redundant mode, standby
Red Redundant mode, fault (HSP
down)
Off Standard mode
Nortel Communication Server 1000
Circuit Card Reference
NN43001-311 01.04 Standard
Release 5.0 23May 2008
Copyright© 2003-2008, Nor tel Networks
.