360 NT5D97 Dual-port DTI2 PRI2 card
10 If required, designate connecting blocks at the MDF or wall mounted
cross-connect terminal.
11 If required, install a Network Channel Terminating Equipment
(NCTE). or Line Terminating Unit (LTU).
12 Add related office data into switch memory.
13 Enable faceplate switchS1. This is the "Loop Enable" switch.
The faceplate LEDs should go on for4 seconds then go off and
the OOS, DIS and ACTLEDs should goon again and stay on.
IF DDCH is installed, the DCH LED should flash 3 times.
14 Run the PRI/DTI Verification Test.
15 Run the PRI status check.
—End—
Procedure 16
Removing the NT5D97
Step Action
1Determine the cabinet and shelf location of the NT5D97 card to
be removed.
2Disable Network Loop using LD 60. The command is DISL "loop
number."
The associated DCHI might need to be disabled first. The faceplate
switch ENB/DIS should not be disabled until both PRI2/DTI2 loops
are disabled first.
3If the NT5D97 card is being completely removed, not replaced,
remove data from memory.
4Remove cross connections at MDF to wall-mountedcross-connect
terminal.
5Tagand disconnect cables from card.
6Rearrange Clock Controller cables if required.
Nortel Communication Server 1000
Circuit Card Reference
NN43001-311 01.04 Standard
Release 5.0 23 May 2008
Copyright© 2003-2008, Nor tel Networks
.