806 NT8D41AA Serial Data Interface Paddle Board
Once the board has been installed, the system software must be configured
to recognize it. Instructions for doing this are found in "Software service
changes" (page 808)".
Option switch settings
Address
Address select switch SW4 and logic on the card alwaysaddress the two
UARTsusing a pair of addresses: 0 and 1, 2 and 3 through 15 and 16. The
settings for this switch are shown in Table312 "SDI paddle board address
switch settings" (page 806).
Table312
SDI paddle board address switch settings
Address Switch SW4
Port 1 Port 2 1 2 3 4
01
off on on on
23
off on on off
45off on off on
67off on off off
89
off off on on
10 11 off off on off
12 13 off off off on
14 15 off off off off
Baud rate
Switches SW2 and SW3 determine the baud rate for each individual port.
The settings for these switches are shown in Table313 "SDI paddle board
baud rate switch settings" (page 806).
Table313
SDI paddle board baud rate switch settings
Port 1 - SW2 Port 2 - SW3
Baud
rate 12341234
150 off off on on off off on on
300 off on off on off on off on
600 off off off on off off off on
1200 off on on off off on on off
2400 off off on off off off on off
4800 off on off off off on off off
9600 off off off off off off off off
Nortel Communication Server 1000
Circuit Card Reference
NN43001-311 01.04 Standard
Release 5.0 23 May 2008
Copyright© 2003-2008, Nor tel Networks
.