54 Overview
Figure 14
Typical trunk interface unit blockdiagram
Coder/Decoder circuit The coder/decoder (codec) performs Analog
to Digital (A/D) and Digital to Analog (D/A) conversion of the line analog
voiceband signal to and from a digital PCM signal. This signal can be coded
and decoded using either the A-Law or the µ-Law companding algorithm.
On some trunk cards the decoding algorithm depends of the type of codec
installed when the board is built. On others, it is an option selected using a
software overlay.
Variablegain filters Audio signals received from the analog phone trunk
are passed through a low-pass A/D monolithic filter that limits the frequency
spread of the input signal to a nominal 200–3400 Hz bandwidth. The audio
signal is then applied to the input of the codec. Audio signals coming
from the CODEC are passed through a low-pass A/D monolithic filter that
integrates the amplitude modulated pulses coming from the CODEC, and
then filters and amplifies the result.
On some of the trunk cards, the gain of these filters can be programmed
by the system controller. This allows the system to make up for line losses
according to the loss plan.
Nortel Communication Server 1000
Circuit Card Reference
NN43001-311 01.04 Standard
Release 5.0 23May 2008
Copyright© 2003-2008, Nor tel Networks
.