Installation and configuration 199
Distance S2 Switch
Position 3 S2 Switch
Position 4 S2 Switch
Position 5
400–533 Off Off On
534–655 Off Off Off
Installation
This section describes how to install and test the Lineside T1 card.
When installed, the Lineside T1 card occupies two card slots. It can be
installed into an NT8D37 IPE module.
When installing the Lineside T1 card into NT8D37 IPE module, determine
the vintage level module. If the 25-pair I/O connectors are partially split
between adjacent IPE card slots, the Lineside T1 card works only in card
slots where Unit 0 of the motherboard card slot appears on the first pair
of the 25-pair I/O connector.
Certain vintage levels carry dedicated 25-pair I/O connectors only for card
slots 0, 4, 8, and 12. These vintage levels are cabled with only 16 pairs
of wires from each card slot to the I/O panel. Some of the 25-pair I/O
connectors are split between adjacent card slots. Other vintage levels cable
each card slot to the I/O panel using a unique, 24-pair connector on the I/O
panel. In these vintage levels, the Lineside T1 card can be installed in any
availablepair of card slots. However, because of the lower number of wire
pairs cabled to the I/O panel in the lower vintage level, only certain card
slots are available to the Lineside T1 card.
See Table95 "Lineside T1 card - NT8D37 IPE module vintage level port
cabling" (page 199) for the vintage level information forthe NT8D37 IPE
modules.
Table 9 5
Lineside T1 card - NT8D37 IPE module vintage level port cabling
Vintage Level Number of ports
cabled to I/O panel
NT8D37AA 16 ports
NT8D37BA 24 ports
NT8D37DC 16 ports
NT8D37DE 16 ports
NT8D37EC 24 ports
This section describes how to install and test the Lineside T1 card.
Nortel Communication Server 1000
Circuit Card Reference
NN43001-311 01.04 Standard
Release 5.0 23May 2008
Copyright© 2003-2008, Nor tel Networks
.