Hayes dialing 469
OK
Reset Hayes parameters
All of the Hayes dialing parameters and S registers remain evenafter the
data call is complete. Similarly, if the dialing mode, keyboard to Hayes
or vice versa, are changed, the parameters remain as specified. The
following command allows youto reset the parameters and S registers to
the defaults. Entering 0 resets to the Hayes default, while entering 1 resets
to the downloaded operating parameters.
CAUTION
All previous instructions are ignored.
Use this command to reset all parameters. It should be the last
command entered, because all previous commands are ignored.
ATZ0
1
OK
Table184 "Hayes parameters and S register reset values" (page 469) lists
all the parameter and S register default values. These are the values
established when the reset command is given.
Table184
Hayes parameters and S register reset values
Parameter Value Description
C 1 * DCD controlDynamic (1)
Forced ON (0)
E 1 * Input character echo Enabled (1)
Disabled (0)
Q0Send Result codesEnabled (1)
Disabled (0)
V1Result codes sent in Verbose format
X1Features selection 0 - 8, 10 - 13
P—Dial method (pulse)
S0 0 *?1 ManualAnswer (if 0)?Auto answer on 1 ring
S1 0Ring count 0
S2 43 Escape sequence character Plus sign (+)
* Parameters that are reset to the downloaded operating parameters when 1 is
entered at the reset command.
Nortel Communication Server 1000
Circuit Card Reference
NN43001-311 01.04 Standard
Release 5.0 23May 2008
Copyright© 2003-2008, Nor tel Networks
.