Physical description 909
In free-run mode, the clock controller does not synchronize on anysource, it
provides its own internal clock to the system. This mode can be used when
the Option 11C is used as a master clock source for other systems in the
network. Free-run mode is undesirable if the Option 11C is intended to
be a slave. It can occur, however,when both the primary and secondary
clock sources are lost due to hardware faultsor when invoked by using
software commands.
In free-run mode, the clock controller does not synchronize on any outside
source. Instead, it provides its own internal clock to the system. This mode
can be used when the CS 1000 acts as a master clock source for other
systems in the network. Free-run mode is undesirable if the CS 1000 is
intended to be a slave to an external network clock. Free-run mode can
occur when both the primary and secondary clock sources are lost due to
hardware faults or invokedusing software commands.
Physical description
Faceplate LEDs
Each motherboard has five DTI/PRI LEDs and one clock controller LED.
The clock controller LED is dual-color (red and green). The clock controller
LED states are described in Table370 "Faceplate LEDs" (page 909).
Table370
Faceplate LEDs
State Definition
On (Red) NTAK20 is equipped and disabled.
On (Green) NTAK20 is equipped, enabled, and is either locked to a
reference or is in free run mode.
Flashing
(Green) NTAK20 is equipped and is attempting to lock (tracking mode) to
a reference. If the LED flashes continuously over an extended
period of time, check the CC STAT in LD 60. If the CC is tracking
this may be an acceptable state. Check for slips and related
clock controller error conditions. If none exist, then this state is
acceptable, and the flashing is identifyingjitter on the reference.
Off NTAK20 is not equipped.
Each of the motherboards have 5 DTI/PRI LEDs and one clock controller
LED.The CC LED is dual-color (red and green), with states represented as
follows:
Table371
Faceplate LEDs
State Definition
On (Red) NTAK20 is equipped and disabled.
Nortel Communication Server 1000
Circuit Card Reference
NN43001-311 01.04 Standard
Release 5.0 23May 2008
Copyright© 2003-2008, Nor tel Networks
.